Closeout Used Open-Box Durston 1061 Pedestal Rolling Mill Stand

This is a customer return due to slight damage during shipping. Selling it as USED OPEN-BOX because the unit is a little bent at the bottom and lightly scratched at the top with some paint chipped off. It comes in original box but it was damaged during shipping and has been reinforced with extra tape. 

Only 1 Available!

For Durston DRM 100, 130 & 150-Also for Durston Mini-Mills & Agile Mills*

The Durston pedestal style rolling mill stand is pre-drilled for all of the Durston Mini-Mills, all the Durston DRM mills, including the reduction gear and non-reduction gear models DRM 100, 130 & 150 and, since April 2019, the Agile line* of Durston rolling mills. The Durston pedestal stand does not fit any version, new or old, of the D2 120, D2 130 or D4 158 over and under rolling mills. 

Includes 4 mounting bolts with nuts and washers for mounting a mill to the stand. *The Agile 165 will have 2 hole that align with the pedestal stand.  The recommended minimum for mounting a mill is to have 2 holes used. Mounting hardware for stand to floor not included. Made in Great Britain. 

Dimensions: 11-3/4" Width x 13-3/4" Depth x 35-3/8" Height (300 mm Width x 350 mm Depth x 900 mm Height) 

If you are unable to mount a pedestal in your shop here is a solution. Get a 1/2" or 3/4" thick sheet of plywood. Have it cut at least 6' long and at least 3' wide. Then drill and mount the pedestal in the center of the plank so the handle grip of the rolling mill is perpendicular to the long dimension of the plank. This base will have plenty of support for any rolling task.