Used Open-Box Foredom M.LX Hang-up Motor Only - 115V

This hang-up motor delivers smooth, low-RPM torque for stone setting and other cuts that need to stay slow and steady, keeping burs pushing cleanly through metal instead of bogging down under load.

This is a used open-box Foredom M.LX hang-up motor only, 115V, that was returned by a customer who believed it was defective; it has been fully tested and is in great working condition, showing some wear typical of a used unit such as dirt, grime, and light scratches. It is supplied as a motor only, with a standard length key tip shaft and a flexible neoprene sheath, ready to drop into an existing flex shaft setup on 110V.

The M.LX motor must be used with a Foredom C.TXR-1 or C.SXR-1 115V foot control or a Foredom C.EMX-1 or C.EMXF-1 115V bench mount control; never plug the motor directly into an outlet.

Features

• High-torque, low-speed flex shaft motor optimized for stone setting applications
• 1/10 HP permanent magnet, ball bearing motor with a 5,000 RPM maximum speed
• Motor-only configuration supplied with shaft and sheath for integrating into an existing flex shaft system
• Ideal for hammer-style handpieces and duplex spring hammer handpieces run at lower speeds
• Helps prevent damage to hammer handpieces with duplex springs by delivering the correct low-speed power
• Standard length key tip shaft and flexible neoprene sheath for smooth, responsive handpiece control
• Handpieces and compatible electronic speed controls are sold separately, so you can configure your system as needed

Compatibility

• Designed for use with hammer handpieces that feature duplex springs; using this motor helps prevent spring breakage
• Well suited to hammer-style handpieces intended to run at lower speeds
• Connects to quick-disconnect style handpieces via the standard key tip shaft and neoprene sheath
• Requires a compatible LX series electronic speed control and must not be used with SR series controls
• Uses a dedicated style of plug that matches compatible LX and TX series electronic controls

Notes

• This motor must be used with a speed control device. Never plug the motor directly into an electrical outlet.
• Successor to earlier stone setting motors such as the EE series, R series, and original L series units.
• Built for stone setters who work primarily at low speeds and need a motor that will not bog down under load.