Extra Large Disk Cutter Set of 2, 1-1/4" & 1-1/2"

This extra-large disk cutter set is built for clean, repeatable cuts in soft non-ferrous sheet. With precision-ground edges and tight tolerances, it excels in a hydraulic press for producing round blanks at 1-1/4" and 1-1/2" diameters. Includes a wood storage box.

Key Features

• Two oversized punches for large discs: 1-1/4" (31.75 mm) and 1-1/2" (38.1 mm)
• Sharp, hardened tool steel cutting edges with close alignment
• Works best in a hydraulic press; also suitable with a proper mallet technique
• Cutter body can be disassembled to clear stuck material
• Includes wood storage box for organization and protection

Specifications

What’s Included

Applications

• Producing large round blanks for bracelets, pendants, conchos, and decorative elements
• Studio production where speed and repeatability are important

How to Use

1. Place the cutter on a rubber or urethane support pad.
2. Lubricate the punch cutting edge (e.g., a dedicated cutting lubricant).
3. Insert the sheet and align the desired punch over the cutting aperture.
4. Operate in a hydraulic press for best results, or strike with a suitable non-marring mallet (avoid nail-driving hammers).
5. Support the opposite side of the cutter with a same-thickness sheet to keep the tool in alignment and reduce sticking.
6. Do not exceed the recommended maximum thickness; cut only soft non-ferrous metals.

Care & Safety

• Keep cutting edges lightly oiled between uses and store in a dry location to prevent rust.
• If a punch sticks, disassemble the tool to remove it safely—do not pry against the cutting edges.
• Using a 95 durometer urethane pad under the cutter can extend tool life.

California Prop 65 Warning:
Cancer and Reproductive Harm. www.P65warnings.ca.gov.