Foredom K.2252 Chisel Carving Kit with Hanger

The Foredom K.2252 Chisel Carving Kit with Hanger is a complete, ready-to-use system for power-assisted carving in wood, plastic, plaster, and soft carving stone. Built around the Series LX permanent magnet motor, this kit delivers high torque at low speeds — ideal for chisel carving and stone setting work that demands precision and control. Every component is matched for compatibility, and the included MAMH-1 motor hanger with bench clamp keeps your workspace organized.

Free Shipping in the Continental USA. If ordered with non-free-shipping items, no shipping will be charged on this kit, but standard ground shipping charges apply to other items in the order.

Features

• M.LX permanent magnet high torque/low speed Series LX flex shaft motor rated to 5,000 RPM
• C.EMX tabletop dial speed control in plastic housing — 115V, converts AC to DC current required by the LX motor
• H.50 reciprocating hammer-type chisel handpiece with textured plastic barrel and tapered aluminum tip
• 17 chisels included across three sets: AKH550, AKHK560, and AKHK570
• MAMH-1 motor hanger with bench clamp for convenient overhead motor mounting
• Also includes flex shaft grease and an accessory tray
• H.50 handpiece engages hammering chisel action with light pressure
• H.50 attaches to any Foredom or standard (USA) key tip flex shaft
• LX motor works with TXR, SXR, and EMX speed controls — not compatible with Series SR speed controls
• 5,000 RPM speed limit on LX motor is ideal for the H.50, which must not be run at high speeds

Specifications

What's Included

• M.LX High Torque/Low Speed 5,000 RPM Motor
• C.EMX Tabletop Speed Control (115V)
• H.50 Chisel Handpiece
• AKH550 — 6-piece chisel set (A-KC503, A-KC504, A-KC505, A-KC506, A-KC509, A-KC510)
• AKHK560 — 5-piece chisel set (A-KC501, A-KC502, A-KC507, A-KC508, A-KC511)
• AKHK570 — 6-piece chisel set (A-KC512, A-KC513, A-KC514, A-KC515, A-KC516, A-KC517)
• MAMH-1 Motor Hanger with bench clamp
• Flex shaft grease
• Accessory tray

Notes

• The LX motor requires speed controls that convert AC to DC current (TXR, SXR, or EMX). It will not work with Series SR speed controls.
• The H.50 chisel handpiece should not be run at high speeds — the LX motor's 5,000 RPM limit makes it the correct match for this handpiece.
• The H.50 requires a constant speed supply; the included EMX tabletop dial control is matched specifically for this purpose.

California Prop 65 Warning:
Cancer and Reproductive Harm. www.P65warnings.ca.gov.