Small Ondulator Corrugating Rolling Mill With 4 Sizes

This smaller corrugating rolling mill — also known as an ondulator — is a simple, direct-drive mill designed for adding a corrugated effect to thin gauges of soft metal sheet. It is used primarily for corrugating thin bezel wire and decorative sheet work. The mill must be mounted in a vise or attached securely to a workbench before use.

For use with soft precious metal sheet up to 24mm wide. Best results are achieved with 30 gauge (0.25mm / 0.010") sheet. Thicker material can be attempted, but the corrugated effect becomes less pronounced — trials with 26 gauge (0.40mm / 0.016") copper sheet produced more of a surface marking effect than true corrugation.

This is a direct-drive mill without the size or leverage required to process hard or thick metals. Attempting to do so risks damage to the rolls or the frame.

Features

• Four different pairs of corrugating rolls ranging from very fine to coarse tooth spacing
• Large top knob for tensioning adjustment
• Mill can be disassembled if rolls become stuck
• Simple direct-drive mechanism — no gearing
• Suitable for corrugating thin bezel wire and decorative sheet
• Must be mounted in a vise or fixed to a workbench

Specifications

Notes

A larger version of this corrugating rolling mill is also available — see item 125.376. This mill is not intended for hard metals or heavy gauges. Use only with soft precious metal sheet within the specified width and gauge range to avoid damage to the rolls or frame.

California Prop 65 Warning:
Cancer and Reproductive Harm. www.P65warnings.ca.gov.