Large Ondulator Corrugating Rolling Mill With 4 Sizes

The Large Ondulator Corrugating Rolling Mill is a direct-drive mill designed for adding precise corrugated textures to thin gauges of soft metal sheet. Ideal for jewelers and metalsmiths working with thin bezel wire or decorative sheet work, this mill produces clean, consistent corrugation across material up to 34mm wide. It must be mounted in a vise or attached to a workbench before use.

This mill includes four different pairs of corrugating rolls, ranging from very fine to coarse tooth spacing, giving you control over the corrugation pattern. Tensioning is adjusted with the large knob on top, and the mill can be disassembled if the rolls become stuck during use.

Best results are achieved with 30 gauge (0.25mm / 0.010") soft precious metal sheet. Thicker material such as 26 gauge (0.40mm / 0.016") copper can be run through the mill, but will produce more of a surface marking effect than true corrugation. This is a simple direct-drive mill without the leverage required for hard or thick metals — attempting to run such material risks damage to the rolls or frame.

Features

• Four pairs of corrugating rolls with varying tooth spacing — very fine to coarse
• Accepts soft metal sheet up to 34mm wide
• Top-mounted tensioning knob for easy adjustment
• Disassemblable design if rolls become stuck
• Must be mounted in a vise or secured to a workbench
• Direct-drive mechanism — not suitable for hard or thick metals
• Best results with 30 gauge (0.25mm / 0.010") soft precious metal sheet

Specifications

Notes

• A smaller version of this corrugating mill is also available — see item 125.375.
• This mill is not designed for hard metals or heavy gauges. Use beyond recommended material specifications may damage the rolls or frame.

California Prop 65 Warning:
Cancer and Reproductive Harm. www.P65warnings.ca.gov.