Nylon Center Positioning Dies For Disc Cutting -Set of Five-1/2" to 1"

This set of 5 center positioning dies is made to fit the V-Line disk cutter 125.1734 but they will also work with other round disk cutting sets that have similar hole sizes including our inch sized disc cutter sets 125.1738, 125.1737 and 125.1790 where they match up with the holes from 1/2" to 1". 

The center positioning dies in this set range from 1/2" to 1" (12.6 mm to 25.3 mm) With these centering dies, you can make perfect washers from your disks for making ring blanks or just plain washers. Made in India.

The set includes one each of these nylon centering dies in the following sizes:

• 1/2" (12.6mm)
• 5/8" (15.8mm)
• 3/4" (18.9mm)
• 7/8" (22.1mm)
• 1" (25.3mm)

To use, cut a hole in your metal with a punch the size of your desired inner ring diameter. Remove the cut disk and place it under a larger punch hole size for what you would like to be the outside diameter of your washer. Use the matching centering die for that hole to center the cut disk. Now clamp the disk between the upper and lower halves of the disk cutter using the Pepetools clamping device. Remove the centering die and replace with the correct cutting die for the hole you are using. Punch the hole and you have now created a washer with a perfectly centered hole.