2 Ounce Pack-Re-Cast-It Gold Alloy Refresher-Replenisher

Re-Cast-It – Alloy Additive for Gold Casting (2 Troy Ounces)

Re-Cast-It is an alloy additive designed for re-casting old or scrap gold. It does not contain gold and is not a substitute for gold, but when mixed with yellow gold it helps restore castings to a bright, clean finish.

Benefits

• Cleans old gold castings, restoring a bright yellow “new gold” look
• Helps eliminate porosity in castings
• Improves metal fluidity
• Reduces reddish surface discoloration from re-cast gold
• De-oxidizes used gold during casting

Sold in a pack of 2 troy ounces (40 DWT).

Mixing Ratios

• 10K Scrap: Add 5 DWT Re-Cast-It + 3.57 DWT fine gold per 100 DWT scrap
• 14K Scrap: Add 2 DWT Re-Cast-It + 2.82 DWT fine gold per 100 DWT scrap
• 18K Scrap: Add 1 DWT Re-Cast-It + 3.00 DWT fine gold per 100 DWT scrap

For white gold, these ratios can be used but effectiveness is limited to 1–2 cycles due to yellowing. For continuous reuse with scrap + fresh mixes, use half the above amounts to avoid excessive deoxidizer buildup.

Melting Instructions

• Place Re-Cast-It at the bottom of the crucible, with scrap on top
• When molten, stir with carbon rod (gas-fired/torch melt) or quartz rod (electric induction melt)
• Fluxing (boric acid recommended) may be required depending on scrap condition
• Works best when scrap is clean from oxides and investment powder

Note: If gold is contaminated with cuprous oxide (red oxide), only limited positive results are expected.

California Prop 65 Warning:
Cancer and Reproductive Harm. www.P65warnings.ca.gov.