Anvils Made In USA

An anvil is the solid backing a bench hammer works against, taking the blow and returning it into the metal. These heat-treated cast iron anvils are made in the USA and hardened to approximately HRC 48–52 for excellent durability and rebound. The top and bottom are milled flat to ensure a full, even hammer strike, and the face is surface-ground to a smooth, accurate finish. The hardness sits in the same proven range as many quality forging hammers, which keeps the anvil face from denting under normal use, a critical advantage for consistent planishing, forming and metalsmithing work.

Features

• Hard face for clean results: Hardness in the HRC 48–52 range delivers good rebound and resists dings from repeated hammer strikes.
• Milled flat top and bottom: Ensures full contact with the hammer face and a stable, level working surface.
• Surface-ground face: Provides a smooth, accurate finish that transfers cleanly to sheet and wire.
• Rebound efficiency: Good rebound returns energy into the workpiece, reducing the number of strikes needed and producing smoother planishing results with less hand fatigue.
• Three size options: Available in 35 lb, 70 lb and 125 lb to match your bench space, workload and material scale.
• Made in the USA: Domestic heat-treated cast iron construction.

Available Options

Notes

• Mount firmly to a stump or stand; add a silicone or rubber pad under the base to reduce ring and improve energy transfer.
• Reserve a clean zone on the face for final planishing, because stamping and texturing work can mar the surface and transfer to finished pieces.
• Slightly radius the edges to prevent unintended marks and reduce stress risers in sheet and wire; keep one edge crisper for deliberate bends.
• Occasionally stone or lightly polish the face to remove minor transfer marks without altering overall flatness.
• Use rawhide or nylon mallets when working pieces that must not be stretched or marked.