Foredom K.1080 Hammer Micromotor Kit-Ships Free

The Foredom K.1080 Adjustable Reciprocating Hammer Micromotor Kit combines precision control and power for stone setting, engraving, and metal texturing. Featuring the H.MH-110 Hammer Handpiece and HP4-960 Variable Speed Foot Control, this dual-voltage micromotor system delivers smooth, adjustable impact and stroke speed up to 2,500 strokes per minute. Designed for professional setters and engravers, it offers quiet, vibration-free performance with no flexible shaft or air compressor required.

Features

• Adjustable reciprocating hammer action for precision stone setting, channel work, and engraving
• Knurled impact force control ring adjusts hammer strength from light touch to full power
• Variable stroke speed: 0–2,500 strokes per minute via control dial
• Hammer action engages only under light pressure, allowing precise tool placement without marking the surface
• Dual voltage (110/120V or 220/240V) with switchable power input for worldwide use
• Includes HP4-960 Variable Speed Foot Control for brush-type motors
• Permanently lubricated, maintenance-free bearings — no oiling required
• Each unit tested by Foredom for consistent performance and durability

Specifications

What's Included

• H.MH-110 Adjustable Reciprocating Hammer Handpiece
• HP4-960 Variable Speed Foot Control
• Adapter for threaded anvil point, installed (HPH8-32)
• 3 threaded anvil points (HP10177)
• Graver holder (HPH8-214) — converts handpiece into a power engraver
• Hex key (5/64") and 2 pins for tightening anvil points
• Open-end wrench (5 mm)
• Extra pair of motor brushes (HP4-163)
• Instruction manuals for H.MH-110 handpiece and K.1080 kit

Notes

• Impact adjustment: Rotate the knurled impact ring to set hammer force; test on similar metal before working on finished pieces.
• Forward-only operation: Always operate in forward mode — running in reverse can permanently damage the handpiece.
• Brush maintenance: Replace carbon brushes when worn below 2 mm (approximately every 200 hours of typical use).
• Overload protection: If the red overload indicator activates, switch off the unit, correct the condition, and restart after a brief pause.
• Engraving use: Install the included graver holder and set stroke speed between 1,000–2,500 spm for optimal control.
• Safety: Always wear eye protection; avoid loose clothing or jewelry during operation. Never immerse the handpiece in liquid.
• Compatible with the optional Foredom AK101 6-Piece Anvil Point Kit for varied textures and setting applications.
• This product is subject to California Proposition 65 warnings.

California Prop 65 Warning:
This product can expose you to chemicals including lead, which is known to the State of California to cause cancer, birth defects or other reproductive harm. www.P65warnings.ca.gov.