Wolf Sand Blaster CP10513 Fuse 3.15A

If your sand blaster won't power on, a blown fuse is often the cause. Foredom part CP10513 is a 3.15 amp replacement cartridge fuse for the Wolf Sand Blaster A-WTSB-10. It's an inexpensive part that protects the unit's electrical components from power surges. Keep a spare at your bench so a blown fuse doesn't stop your finishing, texturing, or surface-prep work.

Compatibility

Fits the Wolf Sand Blaster A-WTSB-10.

Notes

1. Disconnect power. Unplug the sand blaster from the wall outlet before you start any service.
2. Find the fuse holder. It's usually located next to the power cord inlet or on the switch panel.
3. Open the holder. Use a small flat-head screwdriver to release the fuse cap, or press the tabs on the cover to pull it free.
4. Replace the fuse. Take out the old fuse and put in a new 5 x 20 mm cartridge fuse with the same rating. Never use a fuse with a higher amperage. It can leave the unit unprotected.
5. Close up and reconnect. Put the cover back on securely, then plug the machine back in.

Tip: If a new fuse blows right after you install it, stop using the blaster. Have the unit checked for an electrical fault before you replace the fuse again.