Large Round Disk Cutter Set of 2- 1-1/4" (32mm) & 1-1/2" (38mm)

This extra-large disk cutter set is built for clean, repeatable cuts in soft non-ferrous sheet metal. With precision-ground edges and tight tolerances, it excels in a hydraulic press for producing round blanks at 1-1/4" and 1-1/2" diameters. 

Features

• Two oversized punches for large discs: 1-1/4" (31.75 mm) and 1-1/2" (38.1 mm)
• Sharp, hardened tool steel cutting edges with close alignment
• Works best in a hydraulic press; also suitable with proper mallet technique
• Cutter body can be disassembled to clear stuck material
  

Specifications

What's Included

Notes

• Place the cutter on a rubber or urethane support pad and lubricate the cutting edge before use.
• Support the opposite side of the cutter with a same-thickness sheet to maintain alignment and reduce sticking.
• A 95 durometer urethane pad under the cutter can extend tool life.
• Do not strike with a nail-driving hammer — use only a suitable non-marring mallet if not using a press.
• If a punch sticks, disassemble the tool to remove it safely — do not pry against the cutting edges.
• Keep cutting edges lightly oiled between uses and store in a dry location to prevent rust.
• Do not exceed the recommended maximum sheet thickness; cut only soft non-ferrous metals.