A disc cutter punches a clean, repeatable blank out of sheet, so you are not sawing and filing every shape by hand. This set of four hardened tool steel cutters takes teardrop blanks out of soft non-ferrous metals. Each punch is individually fitted to its matching hole to extremely close tolerances, which is what keeps the cut clean and accurate.
The set is sold as a set of four teardrop sizes: 13 x 18 mm, 15 x 21 mm, 19 x 26 mm, and 22 x 30 mm, and ships in a wooden storage box with shaped holes for the cutters. The four sizes cover a range of pendant, earring, and decorative metalwork.
Features
- Set of four teardrop-shaped disc cutters spanning four sizes
- Made from properly hardened tool steel with very sharp cutting edges
- Each punch is individually fitted to its matching die hole with extremely close tolerances
- Works under a mallet or in a hydraulic press
- Cuts soft precious and non-ferrous metals up to 20 gauge thick
- Wooden storage box with shaped holes keeps the cutters organized
- Suits gold, silver, copper, brass, and nickel silver with appropriate care
Compatibility
- Soft, non-ferrous metals only: gold, silver, copper, brass, and nickel silver
- Metal up to 20 gauge thick; do not exceed the maximum recommended thickness
- Use under a mallet or in a hydraulic press
- Not for use with ferrous metals
Notes
What you get:
- 4 teardrop-shaped disc cutters (13 x 18 mm, 15 x 21 mm, 19 x 26 mm, 22 x 30 mm)
- Wooden storage box
How to use a disc cutter:
- Place the disc cutter on top of a rubber pad for support.
- Apply a cutting lubricant, such as Stay Sharp, to the cutting edges of the punch.
- Strike with a suitable mallet, never a nail-driving hammer; a brass mallet is recommended.
- Support the opposite side of the cutter with a sheet of the same-diameter metal being cut to keep the upper and lower parts in alignment and minimize material sticking.
- Do not exceed the maximum recommended metal thickness for the cutter.
- Only cut soft, non-ferrous metals such as brass, copper, silver, and gold.
- Ensure the cutting edges are facing down before striking.
- To prevent rust, keep the cutters lubricated between uses and store them in a dry location.
- Use with a 95 durometer urethane pad to extend the life of the cutters.
- Do not use with ferrous metals.
- Store the cutters lubricated and in a dry location to prevent rust.
- A 95 durometer urethane pad is recommended to extend cutter life.
California Prop 65 Warning: